- c -

• CALCULATE_SYMBOL_TIME_SCAN_DURATION : tal_ed.c
• CC_1_END_FREQUENCY : tal_helper.h
• CC_1_START_FREQUENCY : tal_helper.h
• CC_2_END_FREQUENCY : tal_helper.h
• CC_2_START_FREQUENCY : tal_helper.h
• CC_3_END_FREQUENCY : tal_helper.h
• CC_3_START_FREQUENCY : tal_helper.h
• CC_4_END_FREQUENCY : tal_helper.h
• CC_4_START_FREQUENCY : tal_helper.h
• CC_5_END_FREQUENCY : tal_helper.h
• CC_5_START_FREQUENCY : tal_helper.h
• CC_6_END_FREQUENCY : tal_helper.h
• CC_6_START_FREQUENCY : tal_helper.h
• CC_BAND_0 : tal_helper.h , app_per_mode.h , tal_helper.h
• CC_BAND_1 : tal_helper.h
• CC_BAND_2 : tal_helper.h
• CC_BAND_3 : tal_helper.h
• CC_BAND_4 : tal_helper.h
• CC_BAND_5 : tal_helper.h
• CC_BAND_6 : tal_helper.h
• CC_BAND_8 : app_per_mode.h , tal_helper.h
• CC_BAND_9 : app_per_mode.h , tal_helper.h
• CC_NUMBER_0 : app_per_mode.h , tal_helper.h
• CCA_CH_BUSY : atmega256rfr2.h
• CCA_CH_IDLE : atmega256rfr2.h
• CCA_COMPLETED : atmega256rfr2.h
• CCA_DETECTION_TIME_SYM : atmega256rfr2.h
• CCA_DURATION_SYM : atmega256rfr2.h
• CCA_MODE_0 : atmega256rfr2.h
• CCA_MODE_1 : atmega256rfr2.h
• CCA_MODE_2 : atmega256rfr2.h
• CCA_MODE_3 : atmega256rfr2.h
• CCA_NOT_COMPLETED : atmega256rfr2.h
• CCA_PRE_START_DURATION_US : atmega256rfr2.h
• CCA_PREPARATION_DURATION_US : atmega256rfr2.h
• CCA_PROCESS_TIME_SYM : atmega256rfr2.h
• CCA_START : atmega256rfr2.h
• CCPU_ENDIAN_TO_LE16 : compiler.h
• CCPU_ENDIAN_TO_LE32 : compiler.h
• CCPU_ENDIAN_TO_LE64 : compiler.h
• CHANNEL : app_per_mode.h
• CHANNEL_PAGE : app_per_mode.h
• CHANNELS_SELECT_POS : perf_msg_const.h
• CHIP_RESET_CAUSE_BOD_CPU : mega_reset_cause.h
• CHIP_RESET_CAUSE_EXTRST : mega_reset_cause.h
• CHIP_RESET_CAUSE_JTAG : mega_reset_cause.h
• CHIP_RESET_CAUSE_POR : mega_reset_cause.h
• CHIP_RESET_CAUSE_WDT : mega_reset_cause.h
• CLE16_TO_CPU_ENDIAN : compiler.h
• CLE32_TO_CPU_ENDIAN : compiler.h
• CLE64_TO_CPU_ENDIAN : compiler.h
• CLEAR_ADDR_64 : ieee_const.h
• CLEAR_TRX_IRQ_AMI : tal_internal.h
• CLEAR_TRX_IRQ_AWAKE : tal_internal.h
• CLEAR_TRX_IRQ_BATMON : tal_internal.h
• CLEAR_TRX_IRQ_CCA_ED : tal_internal.h
• CLEAR_TRX_IRQ_PLL_LOCK : tal_internal.h
• CLEAR_TRX_IRQ_PLL_UNLOCK : tal_internal.h
• CLEAR_TRX_IRQ_RX_END : tal_internal.h
• CLEAR_TRX_IRQ_TSTAMP : tal_internal.h
• CLEAR_TRX_IRQ_TX_END : tal_internal.h
• CLIP_VALUE_REG : tfa.c , tal_ed.c
• CMD_ID_LEN : perf_msg_const.h
• CMD_ID_OCTET : compiler.h
• CMD_POS : perf_msg_const.h
• COMPILER_PACK_RESET : compiler.h
• COMPILER_PACK_SET : compiler.h
• CONCAT : tal_irq_handler.c
• CONF_BOARD_ENABLE_USARTA1 : conf_board.h
• CONFIG_ED_THRESHOLD : wait_for_event.c
• CONFIG_INTERRUPT_FORCE_INTC : interrupt.h
• CONFIG_MODE_TX_PWR : peer_search_initiator.c
• CONFIG_SYSCLK_PSDIV : conf_clock.h
• CONT_PULSE_TX_CONFIRM_LEN : perf_msg_const.h
• CONT_WAVE_TX_CONFIRM_LEN : perf_msg_const.h
• CONTINUOUS_RX_ON_MODE : perf_msg_const.h
• CONTINUOUS_TX_MODE : perf_msg_const.h
• CONV_DBM_TO_phyTransmitPower : ieee_const.h
• CONV_phyTransmitPower_TO_DBM : ieee_const.h
• convert_16_bit_to_byte_address : compiler.h
• convert_16_bit_to_byte_array : compiler.h
• convert_32_bit_to_byte_array : compiler.h
• convert_64_bit_to_byte_array : compiler.h
• convert_byte_array_to_16_bit : compiler.h
• convert_byte_array_to_32_bit : compiler.h
• convert_byte_array_to_64_bit : compiler.h
• convert_spec_16_bit_to_byte_array : compiler.h
• COUNT_FOR_VALID_KEY_PRESS : user_interface.c
• cpu_delay_ms : cycle_counter.h
• cpu_delay_us : cycle_counter.h
• CPU_ENDIAN_TO_LE16 : compiler.h
• CPU_ENDIAN_TO_LE32 : compiler.h
• CPU_ENDIAN_TO_LE64 : compiler.h
• cpu_irq_disable : interrupt_avr8.h
• cpu_irq_enable : interrupt_avr8.h
• cpu_irq_is_enabled : interrupt_avr8.h
• cpu_ms_2_cy : cycle_counter.h
• cpu_us_2_cy : cycle_counter.h
• CRC16_NOT_VALID : atmega256rfr2.h
• CRC16_VALID : atmega256rfr2.h
• CRC_SETTING_ON_REMOTE_NODE : app_init.h , app_config.h
• CW_TRANSMISSION_UNDER_PROGRESS : perf_msg_const.h