- p -

• P_ON_TO_CLKM_ATTEMPTS : at86rfx_driver.h
• P_ON_TO_CLKM_AVAILABLE : at86rf230b.h
• PAL_WAIT_1_US : conf_at86rfx.h
• PASS : compiler.h
• pcl_disable_module : power_clocks_lib.h
• pcl_enable_module : power_clocks_lib.h
• pcl_freq_param_t : power_clocks_lib.h
• PCL_NOT_SUPPORTED : power_clocks_lib.h
• PD_ACK_BIT_SET_DISABLE : at86rf230b.h
• PD_ACK_BIT_SET_ENABLE : at86rf230b.h
• PGM_READ_BLOCK : compiler.h
• PGM_READ_BYTE : compiler.h
• PGM_READ_WORD : compiler.h
• PHY_MAX_LENGTH : at86rfx_driver.h
• pll_config_defaults : uc3a3_a4/pll.h
• pll_get_default_rate : uc3a3_a4/pll.h
• PLL_LOCK_ATTEMPTS : at86rfx_driver.h
• PLL_LOCK_TIME_US : at86rf230b.h
• PLL_MAX_HZ : uc3a3_a4/pll.h
• PLL_MAX_STARTUP_CYCLES : uc3a3_a4/pll.h
• PLL_MIN_HZ : uc3a3_a4/pll.h
• PLL_NR_OPTIONS : uc3a3_a4/pll.h
• PLL_OPT_OUTPUT_DIV : uc3a3_a4/pll.h
• PLL_OPT_VCO_RANGE_LOW : uc3a3_a4/pll.h
• PLL_OPT_WBM_DISABLE : uc3a3_a4/pll.h
• PLL_TIMEOUT_MS : uc3a3_a4/pll.h
• PLL_VCO_LOW_THRESHOLD : uc3a3_a4/pll.h
• PM_FREQ_STATUS_FAIL : pm.h
• PM_FREQ_STATUS_OK : pm.h
• PM_MAX_MUL : pm_conf_clocks.c
• PRE_TX_DURATION_US : at86rf230b.h
• PROGRAM_START_ADDRESS : trampoline_uc3.h
• PROGRAM_START_OFFSET : trampoline_uc3.h
• PROTOCOL_IAD : usb_protocol.h